Jump to content
bfields38

Jon's Power Slave

Recommended Posts

Hello I have one of the Jon's power slave wanting to use it with the 2600 flash how do I wire the slave an hack for the 2600 thanks

Share this post


Link to post
Share on other sites
 
 

Thanks for the link on the Jon's board I'm using the 2600 flash do I use the blue wire on the Jon's board Connect it to the on & off switch or don't use at all

Share this post


Link to post
Share on other sites
 

I've never used one of these but looking at the diagram there may be two blue wires. Which one are you talking about? One is labeled switch output, the other is select switch.

Share this post


Link to post
Share on other sites
 
 

Looking at the diagram the middle wire of the three is the switched output. It looks like that wire should be connected to the slaves negative battery wire.

 

But like I said I have not used this controller before.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×