Jump to content
michiganbowbender

Sold Yeti Boards For Sale [with Fs600 Chip]

Recommended Posts

I have two working Yeti boards, one with the 1/4" raised pir for use with the HPWA Fresnel, the other with a non-raised pir for use with a flat Fresnel although it could be modified for use with an HPWA once the correct standoff length was determined. Both were fully checked out today, asking $30.00 each or $55.00 for the pair tyd in the lower 48.

Shown on the right side of the picture.

DSC07000.jpg

Edited by michiganbowbender

Share this post


Link to post
Share on other sites
 

The board with the 1/4 inch raised pir has been sold to Jon.

 

The board with the non-raised pir has been sold as well.

Edited by michiganbowbender

Share this post


Link to post
Share on other sites
 
 
Guest
This topic is now closed to further replies.

×