Jump to content

Recommended Posts

I was just wonder if someone could tell me how the Bigfoot sister board should wired up to a slave fash and the main Bigfoot board?

 

Share this post


Link to post
Share on other sites
 
 

Not trying to discourage you, but this may not the best option available to us Homebrewers to control a slave flash. It can be done, but the PND (digital peanuts are rare & expensive).

 

post-8074-1474486982_thumb.jpg

Share this post


Link to post
Share on other sites
 

Here is one setup I used back when the slavemaster was discontinued.

 

post-8074-1474490589_thumb.jpg

Share this post


Link to post
Share on other sites
 

Here is the wein peanut PND. Those wires get soldered to the trigger wires on whatever vivitar slave flash board you want to use. I tend to use 2600 or 2800's. They both contain a 2800A board inside.

 

post-8074-1474490736_thumb.jpg

 

You'll have to ask Ghoot to include the slave charging programming on the BF board.

Share this post


Link to post
Share on other sites
 

Here's a build of mine. You can see where I positioned the PND next to the camera flash. I mounted the sister board on the side of the BF board.

 

post-8074-1474491673_thumb.jpg

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×