novascotiahunter

Project Box For Slave Flash

9 posts in this topic

I have always used these project boxes from radio shack for vivitar slave builds, but

I can't find them anywhere now, does anyone have a place to get these or something like it.

 

project box

Share this post


Link to post
Share on other sites
 

Check with ghosthunters, I think he was having some 3d printed at one time

Share this post


Link to post
Share on other sites
 
 

I found a few boxes on there that would work but they want $30.99 USD for shipping :o

Share this post


Link to post
Share on other sites
 
Check with ghosthunters, I think he was having some 3d printed at one time

I did have a small project box made up that works perfect with the baby slave. I had my 3D printer guy make it up. He is the same guy we use for making the various snorkels. Works great. But since then and since there was not much interest I just now continue to purchase all my project boxes on eBay. They have so many different shapes and sizes on there it's mind boggling. Bad news is u must wait for a long time til they arrive. I use one specific project box and if I need one smaller I cut this one down. I use it with the baby slave but it has plenty of room. I used it in the SZ7 video build I posted on here in a 1060 case.

Share this post


Link to post
Share on other sites
 
 

That is perfect, I looked on ebay and never saw that one, you are da man.... thank you :hags house:

Share this post


Link to post
Share on other sites
 
http://www.ebay.ca/itm/401081069422?_trksi...K%3AMEBIDX%3AIT

 

I hope the link works and I got it right. These are the ones I buy from this seller for the baby slave. I am sure it is big enough for other slaves.

 

Those are the ones I use for my Viv Slaves in 1060 and 3250 cases. That box is just a tiny bit too wide for fitting in the top of an Otter 3250, so I trim off the sides just to the outside of the lid screw posts, still looks clean and works great. I don't know if the box would accommodate a 3700 slave assembly + capacitor, but it easily holds all components of a 2000, 2600, or 2800.

 

This is the seller I purchase mine from: http://www.ebay.com/itm/5PCS-DIY-Plastic-E...SYAAOSwzgBYyORG

Edited by wvridgerunner

Share this post


Link to post
Share on other sites
 

I have put a couple 3700s in those boxes but I had to do a bit of dremel work on the inside.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now