Jump to content
ingham scrub buck

2 Camera Issues

Recommended Posts

I have 2 camera's that aren't acting correctly.   

First - S600 with a Yeti board.   The red light keeps flashing 5x and will not quit.  The initial start up works fine but when it goes into walk off mode it only flashes non stop. 

Second - S600 with a AIO board.  The camera just fires away uncontrollably.  It will shut down if I turn off the board but once it goes through the initial start up all it does is takes pictures.  

Any help is greatly appreciated.

 

ISB

 

 

Share this post


Link to post
Share on other sites
 

The second one sounds like you need a new board battery. Often when the battery powering the board weaken sufficiently it will trigger continuously until the camera's card is full or those batteries die.

Share this post


Link to post
Share on other sites
 

They yeti board could be the battery holder if it's one of those switched 9v holders. They are notorious for causing problems when they go bad. The second could be the board batteries like Woody mentioned or maybe the sensitivity is turned up too high.

Share this post


Link to post
Share on other sites
 
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×