Jump to content
bowhuntingnut

SSI withFuji J10 not working

Recommended Posts

I have a Fuji j10 with a SSI and a s600 chip as Gary's website says to. When system is started up with switch, I believe it does its normal thing for startup. When I trigger the camera via motion sensor, it will power on the camera, and that's it. It won't take a pic. It then powers down after a few seconds. No pictures are able to be taken through the entire system. I will go and check connections and what not, but just to make sure, this pic axe chip is the correct one, right. S600 program straight from Gary for the Fuji j10. 

Share this post


Link to post
Share on other sites
 

Also , while the camera sits, with the switch turned off, the camera powers on for no reason, then powers off. It shouldn't do anything if the switch is off. 

Share this post


Link to post
Share on other sites
 

Unless you modified the switch on the SSI the switch controls the PIR not the board power. If there's a battery connected to the board it's on and will refresh the camera at it's set interval You may want to pull the battery for a few minutes and allow the board to reset, maybe something got out of time.

Edited by johnnydeerhunter

Share this post


Link to post
Share on other sites
 

Yes sir, that's the correct chip, and as JDH mentioned, the switch on the SS1 only turns off motion detection, not power to the board, so it will still refresh the camera.

Has this one worked before, or are you just setting it up?  Maybe shutter and power are swapped?

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×